Tsymo Pet Feeder Manual Pdf (2024)

FAQs

How to reset automatic pet feeder? ›

If the feeder won't turn on, check if the power adapter, power cable, or batteries are correctly installed. Please make sure the food in the tank is dry, and food size is within 2-15mm (0.07-0.6in) in diameter.

Please set the clock inside the pet feeder before setting feeding. Long press the setting button for 2 seconds, then enter the setting surface, as shown in Fig①. The clock icon is flashing. Press to confirm to enter the time setting.

Reset the feeder to factory settings, holding down the Add Pet ( ) button for 10 seconds (until the light starts alternating red / green and the lid opens and closes).

The buttons lock after 2 minutes of inactivity. The lock icon on the screen indicates that the buttons are locked. Press the center and up button at the same time to unlock the buttons.

Automatic feeders encourage overeating in many cats. Since cats are prone to eating all the food available to them at any given time, they may not be able to regulate themselves when they have access to seemingly unlimited food.

You are recieving the "Outlet is blocked" error message because something has been detected by the infrared light sensor in the opening of the food outlet.

If the router or internet is not working, try resetting the router or contact your internet provider. Power cycle the feeder by turning off the power switch. Wait 10 seconds and turn the power switch back on. Check for other devices near the feeder that use the internet or other wireless signals (such as a microwave).

be using the device for some time. 1) Press and hold the Unlocked Button for 3s to unlock other buttons and screen, the Current Time Setting Icon on the screen flashes, it indicates it enters setting mode.

Thus, more frequent small meals throughout the day are ideal. Divide their daily feed into at least four portions instead of 2 for older cats. Set the feeder to dispense the first serving early in the morning, then every 6 hours.

Are automatic pet feeders good? ›

Overall, automatic pet feeders often work well and do what they are supposed to do. If your pet is thriving on a dry food diet and you are familiar with their eating habits, automatic feeders can be a great option for busy days or short trips. However, remember that a feeder should never be a replacement for you.

A: According to the directions, each single serving is 2 1/2 tsp. So if I am figuring correctly, 1/2 cup would be equivalent to about 9 1/2 servings? You can schedule up to 4 times to feed your pet automatically but the most number of servings per meal is 4. Hope this helps.

Decide on feeding times for your pet and then count how many hours the feeding times are from your CURRENT time – the number of hours is what you will set the timers for. For example, if it's 8 AM and you set one dial to 4 and one to 9, then the corresponding lids will open at 12 pm and 5 pm.

To Set Time: 1. After powering feeder, the LCD will show a blinking 12 for time format setup. Use UP or DOWN buttons to scroll to select 12 hour or 24 hour time format. Press RIGHT button to set time.

The Smart Pet Feeder can be reset by pressing and holding the 'feed' button for 5 seconds until a sound is heard. A reset will erase all settings and data on the Smart Pet Feeder and return it to its original factory settings.

Clear all settings: While the feeder is locked, press and hold the increase button for 6 to 10 seconds. The display will flash twice, and the current time will revert to 00:00, indicating that the reset is complete. The voice recordings will be deleted as well.

Press and hold reset button for 7 seconds until the blue light flashes to enter pairing mode. Geeni app should locate the smart feeder in no time. Use pet feeder in a dry indoor environment only.